Refine
Document Type
Conference Type
- Konferenzartikel (2)
Language
- English (3)
Is part of the Bibliography
- yes (3) (remove)
Keywords
- AlScN (1)
- elastic properties (1)
- laser ultrasound (1)
- magnetron sputter epitaxy (1)
- surface acoustic waves (1)
- thin films (1)
Institute
Open Access
- Closed Access (2)
- Gold (1)
- Open Access (1)
Partial substitution of Al atoms with Sc in wurtzite AlN crystals increases the piezoelectric constants. This leads to an increased electromechanical coupling, which is required for high bandwidths in piezo-acoustic filters. The crystal bonds in Ah-xScxN (AlScN) are softened as function of Sc atomic percentage x, leading to reduction of phase velocity in the film. Combining high Sc content AlScN films with high velocity substrates favors higher order guided surface acoustic wave (SAW) modes [1]. This study investigates higher order SAW modes in epitaxial AlScN on sapphire (Al2O3). Their dispersion for Pt metallized epitaxial AlScN films on Al2O3was computed for two different propagation directions. Computed phase velocity dispersion branches were experimentally verified by the characterization of fabricated SAW resonators. The results indicated four wave modes for the propagation direction (0°, 0°, 0°), featuring 3D polarized displacement fields. The sensitivity of the wave modes to the elastic constants of AlScN was investigated. It was shown that due to the 3D polarization of the waves, all elastic constants have an influence on the phase velocity and can be measured by suitable weighting functions in material constant extraction procedures.
The laser ultrasound (LU) technique has been used to determine dispersion curves for surface acoustic waves (SAW) propagating in AlScN/Al2O3 systems. Polar and non-polar Al0.77Sc0.23N thin films were prepared by magnetron sputter epitaxy on Al2O3 substrates and coated with a metal layer. SAW dispersion curves have been measured for various propagation directions on the surface. This is easily achieved in LU measurements since no additional surface structures need to be fabricated, which would be required if elastic properties are determined with the help of SAW resonators. Variation of the propagation direction allows for efficient use of the system’s anisotropy when extracting information on elastic properties. This helps to overcome the complexity caused by a large number of elastic constants in the film material. An analysis of the sensitivity of the SAW phase velocities (with respect to the elastic moduli and their dependence on SAW propagation direction) reveals that the non-polar AlScN films are particularly well suited for the extraction of elastic film properties. Good agreement is found between experiment and theoretical predictions, validating LU as a non-destructive and fast technique for the determination of elastic constants of piezoelectric thin films.
Laser ultrasound was used to determine dispersion curves of surface acoustic waves on a Si (001) surface covered by AlScN films with a scandium content between 0 and 41%. By including off-symmetry directions for wavevectors, all five independent elastic constants of the film were extracted from the measurements. Results for their dependence on the Sc content are presented and compared to corresponding data in the literature, obtained by alternative experimental methods or by ab-initio calculations.