Refine
Document Type
- Conference Proceeding (2) (remove)
Conference Type
- Konferenzartikel (2)
Language
- English (2)
Has Fulltext
- no (2) (remove)
Is part of the Bibliography
- yes (2) (remove)
Keywords
- Nonlinearity (1)
- Surface acoustic wave (1)
Institute
Open Access
- Closed (1)
- Closed Access (1)
This work focuses on the dependencies between typical design parameters of surface acoustic wave (SAW) resonators and the nonlinear emitted signals of second and third order. The parameters metalization ratio and pitch are used as examples, but the approach can be extended to other design parameters as well. It is shown, that the interaction between the nonlinear current generation and the linear admittance is defining the measured nonlinear power signals. It is also discussed, that changes in linear properties get more pronounced in nonlinear responses. Therefore, slight effects on linear parameters will have significant influence on the observed nonlinearity.
Increasing power density causes increased self-generation of harmonics and intermodulation. As this leads to violations of the strict linearity requirements, especially for carrier aggregation (CA), the nonlinearity must be considered in the design process of RF devices. This raises the demand of accurate simulation models. Linear and nonlinear P-Matrix/COM models are used during the design due to their fast simulation times and accurate results. However, the finite element method (FEM) is useful to get a deeper insight in the device's nonlinearities, as the total field distributions can be visualized. The FE method requires complete sets of material tensors, which are unknown for most relevant materials in nonlinear micro-acoustics. In this work, we perform nonlinear FEM simulations, which allow the calculation of nonlinear field distributions of a lithium tantalate based layered SAW system up to third order. We aim at achieving good correspondence to measured data and determine the contributions of each material layer to the nonlinear signals. Therefore, we use approximations circumventing the issue of limited higher order tensor data. Experimental data for the third order nonlinearity is shown to validate the presented approach.