Refine
Year of publication
Document Type
- Article (reviewed) (10)
- Conference Proceeding (4)
- Contribution to a Periodical (2)
- Article (unreviewed) (2)
- Report (1)
Conference Type
- Konferenzartikel (4)
Is part of the Bibliography
- yes (19)
Keywords
- Energieversorgung (4)
- Digitaler Zwilling (2)
- Lichtbogenofen (2)
- Maschinenbaustudium (2)
- Virtuelles Laboratorium (2)
- Wärmeübertragung (2)
- digital twin (2)
- virtual lab (2)
- Abwärmenutzung (1)
- Boiler (1)
Institute
Open Access
- Open Access (11)
- Closed Access (6)
- Diamond (2)
Ecological concerns on the climatic effects of the emissions from electricity production stipulate the remuneration of electricity grids to accept growing amounts of intermittent regenerative electricity feed-in from wind and solar power. Germany’s eager political target to double regenerative electricity production by 2030 puts pressure on grid operators to adapt and restructure their transmission and distribution grids. The ability of local distribution grids to operate autonomous of transmission grid supply is essential to stabilize electricity supply at the level of German federal states. Although congestion management and collaboration at the distribution system operator (DSO) level are promising approaches, relatively few studies address this issue. This study presents a methodology to assess the electric energy balance for the low-voltage grids in the German federal state of Baden-Württemberg, assuming the typical load curves and the interchange potential among local distribution grids by means of linear programming of the supply function and for typical seasonal electricity demands. The model can make a statement about the performance and development requirements for grid architecture for scenarios in 2035 and 2050 when regenerative energies will—according to present legislation—account for more than half of Germany’s electricity supply. The study details the amendment to Baden-Württemberg’s electricity grid required to fit the system to the requirements of regenerative electricity production. The suggested model for grid analysis can be used in further German regions and internationally to systematically remunerate electricity grids for the acceptance of larger amounts of regenerative electricity inflows. This empirical study closes the research gap of assessing the interchange potential among DSO and considers usual power loads and simultaneously usual electricity inflows.
The German government is aiming to increase the share of renewable energies in the electricity supply to 80% in 2050. To date, however, neither the technical requirements nor the market requirements to implement this aim are provided: Germany is struggling to establish the technical requirements and the market requirements to meet this goal. As an important incentive mechanism, the German government has used and continues to use support measures, such as guaranteed feed-in tariffs, and continuously adapts these to market developments and requirements of the European Union. The purpose of the study is to outline a concept for the implementation of regional flexibility markets in Europe based on a thorough review of technical solutions. The method of a comprehensive review of research in regional flexibility markets of electricity, distribution, and pricing from the study is applied to summarize and discuss the opportunities, risks, and future potentials of grid distribution technology. Based on the insights, a new market-based supply and distribution scheme for electricity, which is aimed to benefit of a fully regenerative, decentral and fairly priced electricity markets on the European level is presented. The study suggests a blockchain based pricing mechanism which shall allow equal market access for consumer, providers, and grid operators and rewards regenerative production and short-distance transmission.
Im Fahrzeug stehen große Wärmeströme zur Verfügung, die nicht genutzt werden. Die Energie des Abgases weist gegenüber der des Motor/Kühlsystems eine wesentlich höhere Arbeitsfähigkeit auf. Untersuchungen zielen dahin, diese thermische Energie zum Beispiel mithilfe eines thermoelektrischen Generators wieder in das System einzukoppeln und als Energiequelle für Verbraucher zu nutzen.
Innovative combined heat, cold and power (Trigeneration) at Offenburg University of Applied Sciences
(2013)
The aim of the paper was to investigate the energy saved in the shift from separate generation of thermal and electrical energy to trigeneration at the energy facility in Offenburg University of Applied Sciences (HS OG). The energy facility at HS OG used a traditional heating system and electricity from grid until 2007 afterwhich they installed a trigeneration system to meet its continuously changing dynamic thermal and electrical demands. This paper highlights the methodology that had been derived to analyze and study the effect of this shift based on the energy consumption data available from 2004 to 2011, which were scarce due to the limited monitoring. From the energy analysis, we concluded that 8 % primary energy was saved in this shift at the energy facility of HS OG. And from economical perspective 5 % useful thermal energy and 39 % useful electrical energy was saved in this shift at the energy facility of HS OG. Nevertheless, the term energy saving, in general, is very relative and complex to define in such a changeover.
The energy supply of Offenburg University of Applied Sciences (HS OG) was changed from separate generation to trigeneration in 2007/2008. Trigeneration was installed for supplying heat, cooling and electrical power at HS OG. In this paper, trigeneration process and its modes of operation along with the layout of the energy facility at HS OG were described. Special emphasis was given to the operation schemes and control strategies of the operation modes: winter mode, transition mode and summer mode. The components used in the energy facility were also outlined. Monitoring and data analysis of the energy system was carried out after the commissioning of trigeneration in the period from 2008 to 2011. Thus, valuable performance data was obtained.
The aim of this research work was to develop a boiler model with few parameters required for energy planning. The showcase considered for this work was the boiler system of the energy center at Offenburg University of Applied Sciences. A grey box model of the boiler was developed systematically starting from model abstraction, simplification, model break-down and to the use of empirical correlations wherever necessary to describe the intermediate effects along with the use of information from manufacturer’s specification in order to reduce parameters. This strategy had resulted in a boiler model with only 6 parameters, namely, nominal burner capacity, water gallery capacity, air ratio, heat capacity of wall, thermal conductance on flue gas and hot water side. Most of these parameters can be obtained through the information available in the spec sheets and thus an energy planner will be able to parameterize the model with low effort. The model was validated with the monitored data of the showcase. It was tested for the start-up, shut-down behavior and the effect of storage.
Packed beds serve as thermal energy storages (TES) and heat exchangers (HEX) in different technological applications. In this paper, a general heterogeneous model of heat transfer in packed beds is developed. It is implemented by lumped element formulation in object-oriented modeling language Modelica and is successful validated with data sets taken from two different experiments reported in literature.
The main advantages of the introduced model are the general, theory-based approach and the lumped element formulation in Modelica. The first point mentioned above should allow to simulate a packed bed TES/HEX without the necessity applying measured data for model calibration or to apply specific heat transfer correlations with restricted application. The second point establishes the possibility to integrate the TES/HEX model within plant models of larger scale without increasing the simulation time drastically.
Zum ersten Mal gibt es mit dem kooperativen Promotionskolleg über „Kleinskalige erneuerbare Energiesysteme – KleE“ für hochqualifizierte Absolventen der Hochschule Offenburg die Möglichkeit zur Promotion innerhalb des engen wissenschaftlichen Austauschs eines Doktorandenkollegs. Betreut werden sie gemeinsam von je einem Universitätsprofessor und einem Hochschulprofessor. In Zusammenarbeit mit der Albert-Ludwigs-Universität Freiburg, dem Zentrum für Erneuerbare Energien (ZEE), und den Fraunhofer-Instituten für Solare Energiesysteme (ISE) sowie für Physikalische Messtechnik (IPM) forschen 15 Doktorandinnen und Doktoranden im Promotionskolleg KleE an interdisziplinären Forschungsthemen.