Refine
Document Type
- Conference Proceeding (6)
- Article (reviewed) (5)
- Master's Thesis (2)
- Bachelor Thesis (1)
- Article (unreviewed) (1)
Conference Type
- Konferenzartikel (6)
Has Fulltext
- yes (15) (remove)
Keywords
Institute
- Fakultät Maschinenbau und Verfahrenstechnik (M+V) (15) (remove)
Open Access
- Diamond (15) (remove)
The use of biochar is an important tool to improve soil fertility, reduce the negative environmental impacts of agriculture, and build up terrestrial carbon sinks. However, crop yield increases by biochar amendment were not shown consistently for fertile soils under temperate climate. Recent studies show that biochar is more likely to increase crop yields when applied in combination with nutrients to prepare biochar-based fertilizers. Here, we focused on the root-zone amendment of biochar combined with mineral fertilizers in a greenhouse trial with white cabbage (Brassica oleracea convar. Capitata var. Alba) cultivated in a nutrient-rich silt loam soil originating from the temperate climate zone (Bavaria, Germany). Biochar was applied at a low dosage (1.3 t ha−1). The biochar was placed either as a concentrated hotspot below the seedling or it was mixed into the soil in the root zone representing a mixture of biochar and soil in the planting basin. The nitrogen fertilizer (ammonium nitrate or urea) was either applied on the soil surface or loaded onto the biochar representing a nitrogen-enhanced biochar. On average, a 12% yield increase in dry cabbage heads was achieved with biochar plus fertilizer compared to the fertilized control without biochar. Most consistent positive yield responses were observed with a hotspot root-zone application of nitrogen-enhanced biochar, showing a maximum 21% dry cabbage-head yield increase. Belowground biomass and root-architecture suggested a decrease in the fine root content in these treatments compared to treatments without biochar and with soil-mixed biochar. We conclude that the hotspot amendment of a nitrogen-enhanced biochar in the root zone can optimize the growth of white cabbage by providing a nutrient depot in close proximity to the plant, enabling efficient nutrient supply. The amendment of low doses in the root zone of annual crops could become an economically interesting application option for biochar in the temperate climate zone.
During the coronavirus crisis, labs had to be offered in digital form in mechanical engineering at short notice. For this purpose, digital twins of more complex test benches in the field of fluid energy machines were used in the mechanical engineering course, with which the students were able to interact remotely to obtain measurement data. The concept of the respective lab was revised with regard to its implementation as a remote laboratory. Fortunately, real-world labs were able to be fully replaced by remote labs. Student perceptions of remote labs were mostly positive. This paper explains the concept and design of the digital twins and the lab as well as the layout, procedure, and finally the results of the accompanying evaluation. However, the implementation of the digital twins to date does not yet include features which address the tactile experience of working in real-world labs.
Lithium-ion batteries show strongly nonlinear behaviour regarding the battery current and state of charge. Therefore, the modelling of lithium-ion batteries is complex. Combining physical and data-driven models in a grey-box model can simplify the modelling. Our focus is on using neural networks, especially neural ordinary differential equations, for grey-box modelling of lithium-ion batteries. A simple equivalent circuit model serves as a basis for the grey-box model. Unknown parameters and dependencies are then replaced by learnable parameters and neural networks. We use experimental full-cycle data and data from pulse tests of a lithium iron phosphate cell to train the model. Finally, we test the model against two dynamic load profiles: one consisting of half cycles and one dynamic load profile representing a home-storage system. The dynamic response of the battery is well captured by the model.
Nowadays decarbonisation of the energy system is one of the main concerns for most governments. Renewable energy technologies, such as rooftop photovoltaic systems and home battery storage systems, are changing the energy system to be more decentralised. As a consequence, new ways of energy business models are emerging, e.g., peer-to-peer energy trading. This new concept provides an online marketplace where direct energy exchange can occur between its participants. The purpose of this study is to conduct a content analysis of the existing literature, ongoing research projects, and companies related to peer-to-peer energy trading. From this review, a summary of the most important aspects and journal papers is assessed, discussed, and classified. It was found that the different energy market types were named in various ways and a proposal for standard language for the several peer-to-peer market types and the different actors involved is suggested. Additionally, by grouping the most important attributes from peer-to-peer energy trading projects, an assessment of the entry barrier and scalability potential is performed by using a characterisation matrix.
Auswirkung eines Importstopps russischer Energieträger auf die Klimaschutzziele in Deutschland
(2022)
Ein Importstopp russischer Energieträger nach Deutschland wird derzeit vermehrt diskutiert. Wir wollen die Diskussion unterstützen, indem wir einen Weg zeigen, wie das Elektrizitätssystem in Deutschland kurzfristig mit geringen Energieimporten auskommt und welche Maßnahmen notwendig sind, um die Klimaschutzziele trotzdem einzuhalten. Die Ergebnisse eines solchen Energiewendeszenarios mit reduzierter Importabhängigkeit werden mit dem Energiesystemmodell MyPyPSA-Ger berechnet. Die wichtigsten Erkenntnisse sind, dass ein zügiger Ausbau Erneuerbarer Energien und von Speichertechnologien • die Abhängigkeit des deutschen Elektrizitätssystems von Energieimporten deutlich reduziert. • auch langfristig keine wesentlichen Importe der Energieträger Erdgas, Steinkohle und Mineralöl nach sich zieht. • über die Klimaziele der Bundesregierung hinaus das 1,5-Grad-Ziel im Elektrizitätssystem erreicht wird.
The contribution of the RoofKIT student team to the SDE 21/22 competition is the extension of an existing café in Wuppertal, Germany, to create new functions and living space for the building with simultaneous energetic upgrading. A demonstration unit is built representing a small cut-out of this extension. The developed energy concept was thoroughly simulated by the student team in seminars using Modelica. The system uses mainly solar energy via PVT collectors as the heat source for a brine-water heat pump (space heating and hot water). Energy storage (thermal and electrical) is installed to decouple generation and consumption. Simulation results confirm that carbon neutrality is achieved for the building operation, consuming and generating around 60 kWh/m2a.
During the coronavirus crisis, labs had to be offered in digital form in mechanical engineering at short notice. For this purpose, digital twins of more complex test benches in the field of fluid energy machines were used in the mechanical engineering course, with which the students were able to interact remotely to obtain measurement data. The concept of the respective lab was revised with regard to its implementation as a remote laboratory. Fortunately, real-world labs were able to be fully replaced by remote labs. Student perceptions of remote labs were mostly positive. This paper explains the concept and design of the digital twins and the lab as well as the layout, procedure, and finally the results of the accompanying evaluation. However, the implementation of the digital twins to date does not yet include features that address the tactile experience of working in real-world labs.
Enhancing engineering creativity with automated formulation of elementary solution principles
(2023)
The paper describes a method for the automated formulation of elementary creative stimuli for product or process design at different levels of abstraction and in different engineering domains. The experimental study evaluates the impact of structured automated idea generation on inventive thinking in engineering design and compares it with previous experimental studies in educational and industrial settings. The outlook highlights the benefits of using automated ideation in the context of AI-assisted invention and innovation.
Electrochemical pressure impedance spectroscopy (EPIS) is an emerging tool for the diagnosis of polymer electrolyte membrane fuel cells (PEMFC). It is based on analyzing the frequency response of the cell voltage with respect to an excitation of the gas-phase pressure. Several experimental studies in the past decade have shown the complexity of EPIS signals, and so far there is no agreement on the interpretation of EPIS features. The present study contributes to shed light into the physicochemical origin of EPIS features, by using a combination of pseudo-two-dimensional modeling and analytical interpretation. Using static simulations, the contributions of cathode equilibrium potential, cathode overpotential, and membrane resistance on the quasi-static EPIS response are quantified. Using model reduction, the EPIS responses of individual dynamic processes are predicted and compared to the response of the full model. We show that the EPIS signal of the PEMFC studied here is dominated by the humidifier. The signal is further analyzed by using transfer functions between various internal cell states and the outlet pressure excitation. We show that the EPIS response of the humidifier is caused by an oscillating oxygen molar fraction due to an oscillating mass flow rate.
A balcony photovoltaic (PV) system, also known as a micro-PV system, is a small PV system consisting of one or two solar modules with an output of 100–600 Wp and a corresponding inverter that uses standard plugs to feed the renewable energy into the house grid. In the present study we demonstrate the integration of a commercial lithium-ion battery into a commercial micro-PV system. We firstly show simulations over one year with one second time resolution which we use to assess the influence of battery and PV size on self-consumption, self-sufficiency and the annual cost savings. We then develop and operate experimental setups using two different architectures for integrating the battery into the micro-PV system. In the passive hybrid architecture, the battery is in parallel electrical connection to the PV module. In the active hybrid architecture, an additional DC-DC converter is used. Both architectures include measures to avoid maximum power point tracking of the battery by the module inverter. Resulting PV/battery/inverter systems with 300 Wp PV and 555 Wh battery were tested in continuous operation over three days under real solar irradiance conditions. Both architectures were able to maintain stable operation and demonstrate the shift of PV energy from the day into the night. System efficiencies were observed comparable to a reference system without battery. This study therefore demonstrates the feasibility of both active and passive coupling architectures.