### Refine

#### Year of publication

- 2015 (255) (remove)

#### Document Type

- Article (unreviewed) (58)
- Article (reviewed) (52)
- Conference Proceeding (52)
- Bachelor Thesis (33)
- Part of a Book (24)
- Book (12)
- Master's Thesis (10)
- Other (7)
- Patent (4)
- Periodical Part (3)

#### Keywords

- Kommunikation (7)
- Ausbildung (6)
- Applikation (5)
- Digitalisierung (5)
- Finite-Elemente-Methode (5)
- Abtragung (4)
- Bildung (4)
- Funktechnik (4)
- Herz (4)
- Physik (4)

#### Institute

- Fakultät Medien und Informationswesen (M+I) (80)
- Fakultät Elektrotechnik und Informationstechnik (E+I) (69)
- Fakultät Maschinenbau und Verfahrenstechnik (M+V) (52)
- Fakultät Betriebswirtschaft und Wirtschaftsingenieurwesen (B+W) (48)
- Rektorat/Verwaltung (2)
- Fakultät Elektrotechnik, Medizintechnik und Informatik (EMI) (1)
- IaF - Institut für angewandte Forschung (1)
- Zentrale Einrichtungen (1)

Forschung im Fokus 2015
(2015)

Campus Sommer 2015
(2015)

Campus Winter 2015/2016
(2015)

Instabilities of the interface between two thin liquid films under DC electroosmotic flow are investigated using linear stability analysis followed by an asymptotic analysis in the long-wave limit. The two-liquid system is bounded by two rigid plates which act as substrates. The Boltzmann charge distribution is considered for the two electrolyte solutions and gives rise to a potential distribution in these liquids. The effect of van der Waals interactions in these thin films is incorporated in the momentum equations through the disjoining pressure. Marginal stability and growth rate curves are plotted in order to identify the thresholds for the control parameters when instabilities set in. If the upper liquid is a dielectric, the applied electric field can have stabilizing or destabilizing effects depending on the viscosity ratio due to the competition between viscous and electric forces. For viscosity ratio equal to unity, the stability of the system gets disconnected from the electric parameters like interface zeta potential and electric double-layer thickness. As expected, disjoining pressure has a destabilizing effect, and capillary forces have stabilizing effect. The overall stability trend depends on the complex contest between all the above-mentioned parameters. The present study can be used to tune these parameters according to the stability requirement.

DEM–FEA estimation of pores arrangement effect on the compressive Young’s modulus for Mg foams
(2015)

This work reports the study of the effect of the pore arrangement on the compressive behavior of Mg foams with regular pore size and porosities ranging from 25% to 45%. Pore arrangements were modeled using Finite Element Analysis (FEA), with random and ordered models, and compared to the estimations obtained for a previous work. The coordinates of the random pore arrangements were firstly generated using Discrete Element Method (DEM), and used in a second stage for modeling the pores by FEA. Estimations were also compared to the experimental results for Mg foams obtained by means of powder metallurgy. Results show important drops in the Young’s moduli as the porosity increases for both, experimental results and FEA estimations. Estimations obtained using ordered pore arrangements presented significant differences when compared to the estimations acquired from models with random arrangements. The randomly arranged models represent more accurately the real topologies of the experimental metallic foams. The Young’s moduli estimated using these models were in excellent agreement with the experiments, whilst the estimations obtained using ordered models presented relative errors significantly higher. The importance of the use of more realistic FEA models for improving the predicting ability of this method was probed, for the study of the mechanical properties of metallic foams.

The automatic classification of the modulation format of a detected signal is the intermediate step between signal detection and demodulation. If neither the transmitted data nor other signal parameters such as the frequency offset, phase offset and timing information are known, then automatic modulation classification (AMC) is a challenging task in radio monitoring systems. The approach of clustering algorithms is a new trend in AMC for digital modulations. A novel algorithm called `highest constellation pattern matching' is introduced to identify quadrature amplitude modulation and phase shift keying signals. The obtained simulation and measurement results outperform the existing algorithms for AMC based on clustering. Finally, it is shown that the proposed algorithm works in a real monitoring environment.

The formation and analysis of ten microporous triazolyl isophthalate based MOFs, including nine isomorphous and one isostructural compound is presented. The compounds 1 M – 3 M with the general formula [ M ( R 1 - R 2 - trz - ia ) ] ∞ 3 ·x H 2 O (M 2+ = Co 2+ , Cu 2+ , Zn 2+ , Cd 2+ ; R 1 = H, Me; R 2 = 2py, 2pym, prz (2py = 2-pyridinyle; 2pym = 2-pyrimidinyle; prz = pyrazinyle)) crystallize with rtl topology. They are available as single crystals and also easily accessible in a multi-gram scale via refluxing the metal salts and the protonated ligands in a solvent. Their isomorphous structures facilitate the synthesis of heteronuclear MOFs; in case of 2 M , Co 2+ ions could be gradually substituted by Cu 2+ ions. The Co 2+ :Cu 2+ ratios were determined by ICP-OES spectroscopy, the distribution of Co 2+ and Cu 2+ in the crystalline samples are investigated by SEM-EDX analysis leading to the conclusions that Cu 2+ is more favorably incorporated into the framework compared to Co 2+ and, moreover, that the distribution of the two metal ions between the crystals and within the crystals is inhomogeneous if the crystals were grown slowly. The various compositions of the heteronuclear materials lead to different colors and the sorption properties for CO 2 and N 2 are dependent on the integrated metal ions.

The instability of ultra-thin films of an electrolyte bordering a dielectric gas in an external tangential electric field is scrutinized. The solid wall is assumed to be either a conducting or charged dielectric surface. The problem has a steady one-dimensional solution. The theoretical results for a plug-like velocity profile are successfully compared with available experimental data. The linear stability of the steady-state flow is investigated analytically and numerically. Asymptotic long-wave expansion has a triple-zero singularity for a dielectric wall and a quadruple-zero singularity for a conducting wall, and four (for a conducting wall) or three (for a charged dielectric wall) different eigenfunctions. For infinitely small wave numbers, these eigenfunctions have a clear physical meaning: perturbations of the film thickness, of the surface charge, of the bulk conductivity, and of the bulk charge. The numerical analysis provides an important result: the appearance of a strong short-wave instability. At increasing Debye numbers, the short-wave instability region becomes isolated and eventually disappears. For infinitely large Weber numbers, the long-wave instability disappears, while the short-wave instability persists. The linear stability analysis is complemented by a nonlinear direct numerical simulation. The perturbations evolve into coherent structures; for a relatively small external electric field, these are large-amplitude surface solitary pulses, while for a sufficiently strong electric field, these are short-wave inner coherent structures, which do not disturb the surface.

Die Erfindung betrifft ein Verfahren zum Spektrum-Monitoring eines vorgegebenen Frequenzbandes, bei dem die spektrale Leistungsdichte (S(f)) innerhalb des vorgegebenen Frequenzbandes für alle in dem Frequenzband enthaltenen Rausch- und Signalanteile bestimmt wird und für das Detektieren des Vorhandenseins eines oder mehrerer Signale innerhalb des vorgegebenen Frequenzbandes das Überschreiten eines Schwellenwertes (λ) durch die spektrale Leistungsdichte (S(f)) ausgewertet wird. Erfindungsgemäß wird der Schwellenwert (λ) abhängig von einer Schätzung einer Verteilungsdichte (hR(S)) für den Rauschanteil der spektralen Leistungsdichte (S(f)) innerhalb des vorgegebenen Frequenzbandes und einem vorgegebenen Wert für die Falschalarmwahrscheinlichkeit (Pfa) berechnet.

Chronic insomnia is defined by difficulties in falling asleep, maintaining sleep, and early morning awakening, and is coupled with daytime consequences such as fatigue, attention deficits, and mood instability. These symptoms persist over a period of at least 3 months (Diagnostic and Statistical Manual 5 criteria). Chronic insomnia can be a symptom of many medical, neurological, and mental disorders. As a disorder, it incurs substantial health-care and occupational costs, and poses substantial risks for the development of cardiovascular and mental disorders, including cognitive deficits. Family and twin studies confirm that chronic insomnia can have a genetic component (heritability coefficients between 42% and 57%), whereas the investigation of autonomous and central nervous system parameters has identified hyperarousal as a final common pathway of the pathophysiology, implicating an imbalance of sleep–wake regulation consisting of either overactivity of the arousal systems, hypoactivity of the sleep-inducing systems, or both. Insomnia treatments include benzodiazepines, benzodiazepine-receptor agonists, and cognitive behavioural therapy. Treatments currently under investigation include transcranial magnetic or electrical brain stimulation, and novel methods to deliver psychological interventions.

Environmental Monitoring is an attractive application field for Wireless Sensor Network (WSN). Water Level Monitoring helps to increase the efficiency of water distribution and management. In Pakistan, the world’s largest irrigation system covers 90.000 km of channels which needs to be monitored and managed on different levels. Especially the sensor systems for the small distribution channels need to be low energy and low cost. The distribution presents a technical solution for a communication system which is developed in a research project being co-funded by German Academic Exchange Service (DAAD). The communication module is based on IEEE-802.15.4 transceivers which are enhanced through Wake-On-Radio (WOR) to combine low-energy and real-time behavior. On higher layers, IPv6 (6LoWPAN) and corresponding routing protocols like Routing Protocol for Low power and Lossy Networks (RPL) can extend range of the network. The data are stored in a database and can be viewed online via a web interface. Of course, also automatic data analysis can be performed.

In this paper, the correlation of the cyclic J-integral, ΔJ, and the cyclic crack-tip opening displacement, ΔCTOD, is studied in the presence of crack closure to assess the question if ΔJ describes the crack-tip opening displacement in this case. To this end, a method is developed to evaluate ΔJ numerically within finite-element calculations. The method is validated for an elastic–plastic material that exhibits Masing behavior. Different strain ranges and strain ratios are considered under fully plastic cyclic conditions including crack closure. It is shown that the cyclic J-integral is the parameter to determine the cyclic crack-tip opening displacement even in cases where crack closure is present.

In this paper, the initial multiaxial yield behavior of three different gray cast iron materials with lamellar shaped graphite inclusions is numerically investigated by means of the finite-element method. Therefore, volume elements including the real microstructure of the materials are loaded bi- and triaxially beyond macroscopic yield. The shape of the obtained yield surfaces are compared to the surfaces of four continuum models which, amongst others, are proposed in literature to describe the inelastic behavior of gray cast iron with lamellar shaped graphite inclusions. It is found that the presented continuum models and the macroscopic yield surfaces obtained with microstructure-based finite-element models deviate. Furthermore, the initial inelastic flow direction is computed at the onset of macroscopic yielding. The analysis show that the inelastic flow is normal to the yield surface.