Refine
Document Type
- Article (reviewed) (1)
- Bachelor Thesis (1)
- Book (1)
- Master's Thesis (1)
Has Fulltext
- yes (4) (remove)
Keywords
- Energieversorgung (4) (remove)
Institute
Open Access
- Open Access (2)
- Closed (1)
- Closed Access (1)
Entwicklung eines miniaturisierten Energieversorgungs-Moduls zur autarken Versorgung von Funkmodulen
(2017)
Diese Abschlussarbeit beschäftigt sich mit der Entwicklung eines miniaturisierten Energieversorgungs-Moduls. Das Modul soll gleichzeitig aus drei Energy-Harvestern Energie sammeln und diese in einem Doppelschichtkondensator zwischenspeichern. Diese Energie kann anschließend von einem Funksensorknoten zum Sammeln und Übermitteln von Daten genutzt werden.
Solch ein aufgebautes System verspricht bei einem geringen Volumen eine hohe Lebensdauer,geringen Wartungsaufwand und eine hohe Leistung, ohne dass eine drahtgebundene Energieversorgung oder große Batterien notwendig sind.
Nach dem Erstellen eins Konzepts und der Auswahl der dafür passenden Komponenten wurde zunächst ein Evaluations-Board aufgebaut. Auf diesem wurden alle in Frage kommenden Komponenten vermessen und die Funktion getestet. Aus den dadurch erworbenen Erkenntnissen wurde das miniaturisierte Energieversorgungs-Modul entwickelt. Das miniaturisierte Modul bietet folgende Möglichkeiten: Aus drei verschiedenen Energy Harvestern wird gleichzeitig die Energie gesammelt und aufbereitet. Durch die Nutzung eines effizienten Wandler-Moduls wird bei der Energieaufbereitung eine Effizienz von über 85 % erreicht. Drei Wandler-Module verbrauchen zusammen lediglich eine Leistung von P = 3, 459 µW. Der Maximum Power Point jedes einzelnen Harvesters kann separat eingestellt werden. Auch alle anderen Komponenten werden stromsparend gewählt. Die Energie wird in einem 1, 5 F Doppelschichtkondensator gespeichert. Zusätzlich wird als Backup-Energieversorgung eine Lithium Knopfzelle eingesetzt.
Dadurch können auch sicherheitskritische Anwendungen realisiert werden. Konnte durch die Energy Harvester nicht genügend Energie gesammelt werden, wird die Batterie dem Funksensorknoten zugeschaltet. Das miniaturisierte Modul hat die Maße 20 mm x 40 mm. Nach abschließenden Messungen mit einem neu implementierten Funksensorknoten, der in einer anderen Bachelorthesis entstanden ist [1], wurde eine Sendewiederholrate von 1, 1 s nachgewiesen. Dies stellt einen sehr guten Wert dar und reicht für die meisten Anwendungen aus.
Zuletzt wird aus allen Komponenten inklusive des Funksensorknotens ein Demonstrationsmuster zusammengebaut. Dieses hat die Maße von 5 cm x 5 cm x 5 cm und kann zur weiterführenden Forschung oder als Anschauungsmaterial genutzt werden.
Energie aus erneuerbaren Ressourcen ist nicht immer beliebig verfügbar. Je nach Jahreszeit und Witterung variiert beispielsweise die durch Solarparks oder Windkraftanlagen zur Verfügung gestellte Leistung. Durch den kontinuierlichen Ausbau der erneuerbaren Energien wird sich die Volatilität im Energiesystem in Zukunft immer stärker ausprägen. Die Industrie auf die sich ändernden Versorgungsstrukturen vorzubereiten und anzupassen ist eine große Herausforderung der nächsten Jahrzehnte. Unternehmen müssen zukünftig ihre Prozesse und Betriebsorganisation so gestalten können, dass sich der Energieverbrauch zumindest in Teilen flexibel an das volatile Energieangebot anpassen kann. Neben der Entwicklung von Technologien, Konzepten und Maßnahmen zur energetischen Flexibilisierung von industriellen Prozessen liegt ein zweiter Schwerpunkt zukünftiger Arbeiten auf der Entwicklung einer durchgängigen IT-Infrastruktur, mit der Unternehmen und Energieanbieter in Zukunft Informationen von der Produktionsmaschine bis zu den Energiemärkten bereitstellen und austauschen können. Dies führt zu einem Paradigmenwechsel im Betrieb industrieller Prozesse - weg vom kontinuierlichen und rein nachfragegetriebenen Energieverbrauch hin zum anpassbaren, energieflexiblen Betrieb industrieller Anlagen. Dieses Nachschlagewerk stellt die wichtigsten Ergebnisse der Forschung im Rahmen des Kopernikus-Projekts Synergie vor und verdeutlicht richtungsweisende Erkenntnisse für weitere Entwicklungen in dem noch jungen Feld der industriellen Energieflexibilität.
Ecological concerns on the climatic effects of the emissions from electricity production stipulate the remuneration of electricity grids to accept growing amounts of intermittent regenerative electricity feed-in from wind and solar power. Germany’s eager political target to double regenerative electricity production by 2030 puts pressure on grid operators to adapt and restructure their transmission and distribution grids. The ability of local distribution grids to operate autonomous of transmission grid supply is essential to stabilize electricity supply at the level of German federal states. Although congestion management and collaboration at the distribution system operator (DSO) level are promising approaches, relatively few studies address this issue. This study presents a methodology to assess the electric energy balance for the low-voltage grids in the German federal state of Baden-Württemberg, assuming the typical load curves and the interchange potential among local distribution grids by means of linear programming of the supply function and for typical seasonal electricity demands. The model can make a statement about the performance and development requirements for grid architecture for scenarios in 2035 and 2050 when regenerative energies will—according to present legislation—account for more than half of Germany’s electricity supply. The study details the amendment to Baden-Württemberg’s electricity grid required to fit the system to the requirements of regenerative electricity production. The suggested model for grid analysis can be used in further German regions and internationally to systematically remunerate electricity grids for the acceptance of larger amounts of regenerative electricity inflows. This empirical study closes the research gap of assessing the interchange potential among DSO and considers usual power loads and simultaneously usual electricity inflows.
Increasing global energy demand and the need to transition to sustainable energy sources to mitigate climate change, highlights the need for innovative approaches to improve the resilience and sustainability of power grids. This study focuses on addressing these challenges in the context of Morocco's evolving energy landscape, where increasing energy demand and efforts to integrate renewable energy require grid reinforcement strategies. Using renewable energy sources such as photovoltaic systems and energy storage technologies, this study aims to develop a methodology for strengthening rural community grids in Morocco.
Traditional reinforcement measures such as line and transformer upgrades will be investigated as well as the integration of power generation from photovoltaic systems, which offer a promising way to utilise Morocco's abundant solar resources. In addition, energy storage systems will be analysed as potential solutions to the challenges of grid stability and resilience. Using comprehensive data analysis, scenario planning and simulation methods with the open-source simulation software Panda Power, this study aims to assess the impact of different grid reinforcement measures, including conventional methods, photovoltaic integration, and the use of energy storage, on grid performance and sustainability. The results of this study provide valuable insights into the challenges and opportunities of transitioning to a more resilient and sustainable energy future in Morocco.
Based on a rural medium-voltage grid in Souihla, Morocco, three scenarios were carried out to assess the impact of demand growth in 2030 and 2040. The first scenario focuses on conventional grid reinforcement measures, while the second scenario incorporates energy from residential photovoltaic systems. The third scenario analyses the integration of storage systems and their impact on grid reinforcement in 2030.
The simulations with energy from photovoltaic systems show a reduction in grid reinforcement measures compared to the scenario without solar energy. In addition, the introduction of a storage system in 2030 led to a significant reduction in the required installed transformer capacity and fewer congested lines. Furthermore, the results emphasized the role of storage in stabilizing grid voltage levels.
In summary, the results highlighted the potential benefits of integrating energy from photovoltaics and storage into the grid. This integration not only reduces the need for transformers and overall grid infrastructure but also promotes a more efficient and sustainable energy system.