Refine
Year of publication
- 2015 (50) (remove)
Document Type
- Article (reviewed) (50) (remove)
Has Fulltext
- no (50)
Is part of the Bibliography
- yes (50) (remove)
Keywords
- Batterie (2)
- Brennstoffzelle (2)
- Durchfluss (2)
- Dünnschichtchromatographie (2)
- Eingebettetes System (2)
- Fotovoltaik (2)
- Haustechnik (2)
- Mikrostruktur (2)
- Nanotechnologie (2)
- Polymere (2)
Institute
- Fakultät Maschinenbau und Verfahrenstechnik (M+V) (30)
- INES - Institut für nachhaltige Energiesysteme (14)
- Fakultät Elektrotechnik und Informationstechnik (E+I) (bis 03/2019) (12)
- Fakultät Wirtschaft (W) (8)
- ivESK - Institut für verlässliche Embedded Systems und Kommunikationselektronik (2)
- IUAS - Institute for Unmanned Aerial Systems (1)
Open Access
- Closed Access (23)
- Open Access (9)
Adsorption of N2 and CO2 on Activated Carbon, AlO(OH) Nanoparticles, and AlO(OH) Hollow Spheres
(2015)
Adsorption behaviors of nitrogen and CO2 on Norit R1 Extra and AlO(OH) nanoparticles and hollow spheres were measured under different temperature and pressure conditions using a magnetic suspension balance. Independent from the substrate investigated, all isotherms increase at lower pressure, reach a maximum, and then decrease with increasing pressure. In addition, selected experimental data were correlated with different model approaches and compared with reliable literature data. In case of CO2 on AlO(OH), capillary condensation was observed at two defined temperatures. The results suggest that the conversion of the liquid into a supercritical adsorbate phase does not take place suddenly.
Phosphate-based inorganic–organic hybrid nanoparticles (IOH-NPs) with the general composition [M]2+[Rfunction(O)PO3]2– (M = ZrO, Mg2O; R = functional organic group) show multipurpose and multifunctional properties. If [Rfunction(O)PO3]2– is a fluorescent dye anion ([RdyeOPO3]2–), the IOH-NPs show blue, green, red, and near-infrared fluorescence. This is shown for [ZrO]2+[PUP]2–, [ZrO]2+[MFP]2–, [ZrO]2+[RRP]2–, and [ZrO]2+[DUT]2– (PUP = phenylumbelliferon phosphate, MFP = methylfluorescein phosphate, RRP = resorufin phosphate, DUT = Dyomics-647 uridine triphosphate). With pharmaceutical agents as functional anions ([RdrugOPO3]2–), drug transport and release of anti-inflammatory ([ZrO]2+[BMP]2–) and antitumor agents ([ZrO]2+[FdUMP]2–) with an up to 80% load of active drug is possible (BMP = betamethason phosphate, FdUMP = 5′-fluoro-2′-deoxyuridine 5′-monophosphate). A combination of fluorescent dye and drug anions is possible as well and shown for [ZrO]2+[BMP]2–0.996[DUT]2–0.004. Merging of functional anions, in general, results in [ZrO]2+([RdrugOPO3]1–x[RdyeOPO3]x)2– nanoparticles and is highly relevant for theranostics. Amine-based functional anions in [MgO]2+[RaminePO3]2– IOH-NPs, finally, show CO2 sorption (up to 180 mg g–1) and can be used for CO2/N2 separation (selectivity up to α = 23). This includes aminomethyl phosphonate [AMP]2–, 1-aminoethyl phosphonate [1AEP]2–, 2-aminoethyl phosphonate [2AEP]2–, aminopropyl phosphonate [APP]2–, and aminobutyl phosphonate [ABP]2–. All [M]2+[Rfunction(O)PO3]2– IOH-NPs are prepared via noncomplex synthesis in water, which facilitates practical handling and which is optimal for biomedical application. In sum, all IOH-NPs have very similar chemical compositions but can address a variety of different functions, including fluorescence, drug delivery, and CO2 sorption.
Lithium-oxygen cells with organic electrolyte suffer high overpotentials during charge, indicating asymmetric charge/discharge reaction mechanisms. We present a multi-physics dynamic modeling and simulation study of the Li/O2 cell cycling behavior. We present three different multi-step mechanisms of the 2 Li + O2 ⇄ Li2O2 cell reaction, (A) a reversible 5-step mechanism, (B) a partially irreversible 6-step mechanism, and (C) a partially irreversible 8-step mechanism that includes reactions of a redox mediator. Model predictions are compared to experimental galvanostatic cycling data of Swagelok cells without and with 2,2,6,6-tetramethylpiperidinyloxyl (TEMPO) as redox mediator. All mechanisms are able to predict the discharge behavior in good agreement to the experimental results. The experimentally observed high charge overpotentials as well as their reduction by using a redox mediator can be qualitatively reproduced with the irreversible reaction mechanisms. However, the particular shape of the experimental charge curve with continuously increasing charge overpotential cannot be reproduced with the present mechanisms.
The durability of polymer electrolyte membrane fuel cells (PEMFC) is governed by a nonlinear coupling between system demand, component behavior, and physicochemical degradation mechanisms, occurring on timescales from the sub-second to the thousand-hour. We present a simulation methodology for assessing performance and durability of a PEMFC under automotive driving cycles. The simulation framework consists of (a) a fuel cell car model converting velocity to cell power demand, (b) a 2D multiphysics cell model, (c) a flexible degradation library template that can accommodate physically-based component-wise degradation mechanisms, and (d) a time-upscaling methodology for extrapolating degradation during a representative load cycle to multiple cycles. The computational framework describes three different time scales, (1) sub-second timescale of electrochemistry, (2) minute-timescale of driving cycles, and (3) thousand-hour-timescale of cell ageing. We demonstrate an exemplary PEMFC durability analysis due to membrane degradation under a highly transient loading of the New European Driving Cycle (NEDC).
Seven cell design concepts for aqueous (alkaline) lithium–oxygen batteries are investigated using a multi-physics continuum model for predicting cell behavior and performance in terms of the specific energy and specific power. Two different silver-based cathode designs (a gas diffusion electrode and a flooded cathode) and three different separator designs (a porous separator, a stirred separator chamber, and a redox-flow separator) are compared. Cathode and separator thicknesses are varied over a wide range (50 μm–20 mm) in order to identify optimum configurations. All designs show a considerable capacity-rate effect due to spatiotemporally inhomogeneous precipitation of solid discharge product LiOH·H2O. In addition, a cell design with flooded cathode and redox-flow separator including oxygen uptake within the external tank is suggested. For this design, the model predicts specific power up to 33 W/kg and specific energy up to 570 Wh/kg (gravimetric values of discharged cell including all cell components and catholyte except housing and piping).
The energy system of the future will transform from the current centralised fossil based to a decentralised, clean, highly efficient, and intelligent network. This transformation will require innovative technologies and ideas like trigeneration and the crowd energy concept to pave the way ahead. Even though trigeneration systems are extremely energy efficient and can play a vital role in the energy system, turning around their deployment is hindered by various barriers. These barriers are theoretically analysed in a multiperspective approach and the role decentralised trigeneration systems can play in the crowd energy concept is highlighted. It is derived from an initial literature research that a multiperspective (technological, energy-economic, and user) analysis is necessary for realising the potential of trigeneration systems in a decentralised grid. And to experimentally quantify these issues we are setting up a microscale trigeneration lab at our institute and the motivation for this lab is also briefly introduced.
Chronic insomnia is defined by difficulties in falling asleep, maintaining sleep, and early morning awakening, and is coupled with daytime consequences such as fatigue, attention deficits, and mood instability. These symptoms persist over a period of at least 3 months (Diagnostic and Statistical Manual 5 criteria). Chronic insomnia can be a symptom of many medical, neurological, and mental disorders. As a disorder, it incurs substantial health-care and occupational costs, and poses substantial risks for the development of cardiovascular and mental disorders, including cognitive deficits. Family and twin studies confirm that chronic insomnia can have a genetic component (heritability coefficients between 42% and 57%), whereas the investigation of autonomous and central nervous system parameters has identified hyperarousal as a final common pathway of the pathophysiology, implicating an imbalance of sleep–wake regulation consisting of either overactivity of the arousal systems, hypoactivity of the sleep-inducing systems, or both. Insomnia treatments include benzodiazepines, benzodiazepine-receptor agonists, and cognitive behavioural therapy. Treatments currently under investigation include transcranial magnetic or electrical brain stimulation, and novel methods to deliver psychological interventions.