Refine
Document Type
- Article (reviewed) (3) (remove)
Language
- English (3)
Has Fulltext
- no (3)
Is part of the Bibliography
- yes (3) (remove)
Keywords
- Nonlinearity (2)
- Edge waves (1)
- Finite Elemant Method (1)
- Finite element method (1)
- Phononic crystal (1)
- Rayleigh waves (1)
- Surface Acoustic Waves (1)
- Wedge waves (1)
Institute
Open Access
- Closed (3) (remove)
In this work the nonlinear behavior of layered surface acoustic wave (SAW) resonators is studied with the help of finite element (FE) computations. The full calculations depend strongly on the availability of accurate tensor data. While there are accurate material data for linear computations, the complete sets of higher-order material constants, needed for nonlinear simulations, are still not available for relevant materials. To overcome this problem, scaling factors were used for each available nonlinear tensor. The approach here considers piezoelectricity, dielectricity, electrostriction, and elasticity constants up to the fourth order. These factors act as a phenomenological estimate for incomplete tensor data. Since no set of fourth-order material constants for LiTaO3 is available, an isotropic approximation for the fourth-order elastic constants was applied. As a result, it was found that the fourth-order elastic tensor is dominated by one-fourth order Lamé constant. With the help of the FE model, derived in two different, but equivalent ways, we investigate the nonlinear behavior of a SAW resonator with a layered material stack. The focus was set to third-order nonlinearity. Accordingly, the modeling approach is validated using measurements of third-order effects in test resonators. In addition, the acoustic field distribution is analyzed.
Acoustic waves are investigated which are guided at the edge (apex line) of a wedge-shaped elastic body or at the edge of an elastic plate. The edges contain a periodic sequence of modifications, consisting either of indentations or inclusions with a different elastic material which gives rise to high acoustic mismatch. Dispersion relations are computed with the help of the finite element method. They exhibit zero-group velocity points on the dispersion branches of edge-localized acoustic modes. These special points also occur at Bloch-Floquet wavenumbers away from the Brillouin zone boundary. Deep indentations lead to flat branches corresponding to largely non-interacting, Einstein-oscillator like vibrations of the tongues between the grooves of the periodic structure. Due to the nonlinearity of the elastic media, quantified by their third-order elastic constants, an acoustic mode localized at a periodically modified edge generates a second harmonic which partly consists of surface and plate modes propagating into the elastic medium in the direction vertical to the edge. This acoustic radiation at the second-harmonic frequency is investigated for an elastic plate and a truncated sharp-angle wedge with periodic inclusions at their edges. Unlike nonlinear bulk wave generation by surface acoustic waves in an interdigital structure, surface and plate mode radiation by edge-localized modes can be visualized directly in laser-ultrasound experiments.
Surface treatment intensity monitoring is still an open and challenging nondestructive testing problem. For the estimation of residual stress with ultrasonic measurements, local linear and nonlinear elastic constants are needed as input. In this paper, nonlinear elastic-wave interactions (also called wave mixing or scattering) — namely, the generation of secondary ultrasonic waves in a nonlinear medium — are considered as a prospective means for near-surface nonlinear elastic parameter evaluation. The allowed interactions between bulk and surface waves, as well as the dependence of the scattering efficiency on the frequency and angle between source waves, were investigated through an analytical model, then compared with FEM simulations and experimental results. Finally, possible future steps for the development of the applied methods for the determination of near-surface higher-order elastic constants are discussed. In addition, several problem-relevant data processing procedures are presented.