Refine
Year of publication
- 2021 (2) (remove)
Document Type
Conference Type
- Konferenzartikel (1)
Language
- English (2)
Has Fulltext
- no (2) (remove)
Is part of the Bibliography
- yes (2)
Keywords
- Acoustical properties (1)
- Crystal structure (1)
- Epitaxy (1)
- Finite-element analysis (1)
- Interdigital transducers (1)
- Rayleigh waves (1)
- Surface acoustic waves (1)
- Wave mechanics (1)
Institute
Open Access
- Closed Access (2)
Increasing power density causes increased self-generation of harmonics and intermodulation. As this leads to violations of the strict linearity requirements, especially for carrier aggregation (CA), the nonlinearity must be considered in the design process of RF devices. This raises the demand of accurate simulation models. Linear and nonlinear P-Matrix/COM models are used during the design due to their fast simulation times and accurate results. However, the finite element method (FEM) is useful to get a deeper insight in the device's nonlinearities, as the total field distributions can be visualized. The FE method requires complete sets of material tensors, which are unknown for most relevant materials in nonlinear micro-acoustics. In this work, we perform nonlinear FEM simulations, which allow the calculation of nonlinear field distributions of a lithium tantalate based layered SAW system up to third order. We aim at achieving good correspondence to measured data and determine the contributions of each material layer to the nonlinear signals. Therefore, we use approximations circumventing the issue of limited higher order tensor data. Experimental data for the third order nonlinearity is shown to validate the presented approach.
Properties of higher-order surface acoustic wave modes in Al(1-x)Sc(x)N / sapphire structures
(2021)
In this work, surface acoustic wave (SAW) modes and their dependence on propagation directions in epitaxial Al0.68Sc0.32N(0001) films on Al2O3(0001) substrates were studied using numerical and experimental methods. In order to find optimal propagation directions for higher-order SAW modes, phase velocity dispersion branches of Al0.68Sc0.32N on Al2O3 with Pt mass loading were computed for the propagation directions <11-20> and <1-100> with respect to the substrate. Experimental investigations of phase velocities and electromechanical coupling were performed for comparison with the numerical results. Simulations carried out with the finite element method (FEM) and with a Green function approach allowed identification of each wave type, including Rayleigh, Sezawa and shear horizontal wave modes. For the propagation direction <1-100>, significantly increased wave guidance of the Sezawa mode compared to other directions was observed, resulting in enhanced electromechanical coupling (k2eff = 1.6 %) and phase velocity (vphase = 6 km/s). We demonstrated, that selecting wave propagation in <1-100> with high mass density electrodes results in increased electromechanical coupling without significant reduction in phase velocities for the Sezawa wave mode. An improved combination of metallization, Sc concentration x, and SAW propagation direction is suggested which exhibits both high electromechanical coupling (k2eff > 6 %) and high velocity (vphase = 5.5 km/s) for the Sezawa mode.