Refine
Year of publication
- 2021 (3) (remove)
Document Type
Conference Type
- Konferenzartikel (1)
Language
- English (3)
Has Fulltext
- no (3)
Is part of the Bibliography
- yes (3)
Keywords
- Optical phase matching (1)
- Silicon crystal (1)
- Surface acoustic waves (1)
- Wave propagation (1)
- Waveguides (1)
Institute
Open Access
- Closed Access (3)
Propagation of acoustic waves is considered in a system consisting of two stiff quarter-spaces connected by a planar soft layer. The two quarter-spaces and the layer form a half-space with a planar surface. In a numerical study, surface waves have been found and analyzed in this system with displacements that are localized not only at the surface, but also in the soft layer. In addition to the semi-analytical finite element method, an alternative approach based on an expansion of the displacement field in a double series of Laguerre functions and Legendre polynomials has been applied.
It is shown that a number of branches of the mode spectrum can be interpreted and remarkably well described by perturbation theory, where the zero-order modes are the wedge waves guided at a rectangular edge of the stiff quarter-spaces or waves guided at the edge of a soft plate with rigid surfaces.
For elastic moduli and densities corresponding to the material combination PMMA–silicone–PMMA, at least one of the branches in the dispersion relation of surface waves trapped in the soft layer exhibits a zero-group velocity point.
Potential applications of these 1D guided surface waves in non-destructive evaluation are discussed.
Surface acoustic waves are propagated toward the edge of an anisotropic elastic medium (a silicon crystal), which supports leaky waves with a high degree of localization at the tip of the edge. At an angle of incidence corresponding to phase matching with this leaky wedge wave, a sharp peak in the reflection coefficient of the surface wave was found. This anomalous reflection is associated with efficient excitation of the leaky wedge wave. In laser ultrasound experiments, surface acoustic wave pulses were excited and their reflection from the edge of the sample and their partial conversion into leaky wedge wave pulses was observed by optical probe-beam deflection. The reflection scenario and the pulse shapes of the surface and wedge-localized guided waves, including the evolution of the acoustic pulse traveling along the edge, have been confirmed in detail by numerical simulations.
Increasing power density causes increased self-generation of harmonics and intermodulation. As this leads to violations of the strict linearity requirements, especially for carrier aggregation (CA), the nonlinearity must be considered in the design process of RF devices. This raises the demand of accurate simulation models. Linear and nonlinear P-Matrix/COM models are used during the design due to their fast simulation times and accurate results. However, the finite element method (FEM) is useful to get a deeper insight in the device's nonlinearities, as the total field distributions can be visualized. The FE method requires complete sets of material tensors, which are unknown for most relevant materials in nonlinear micro-acoustics. In this work, we perform nonlinear FEM simulations, which allow the calculation of nonlinear field distributions of a lithium tantalate based layered SAW system up to third order. We aim at achieving good correspondence to measured data and determine the contributions of each material layer to the nonlinear signals. Therefore, we use approximations circumventing the issue of limited higher order tensor data. Experimental data for the third order nonlinearity is shown to validate the presented approach.